Settings; General; Step One; Possible Settings For The Fronius String Control 250/30 Dcd Df - Fronius 250/30 DCD DF Operating Instructions Manual

Settings

General

All settings for the Fronius String Control 250/30 DCD DF are applied using the "Fronius
Solar.access" software.

Step one

1
2
3
Possible settings
for the Fronius
String Control
250/30 DCD DF
Strings per meas- Enter the number of PV module strings for each measuring channel.
uring channel This results in automatic correction of measuring channel deviations, which would only be
required if there were a different number of strings per channel.
Max. energy devi- The 5 measuring channels record the total current from the connected solar module strings
ation over the entire feed-in day. In the evening, the Fronius String Control 250/30 DCD DF cal-
culates the mean for all the measuring channels and compares the current on each meas-
uring channel with the mean for all measuring channels. If the Fronius String Control 250/
30 DCD DF detects that one of the measuring channels is deviating from this mean, a sta-
tus code is sent to the Fronius Datalogger.
In the "Max. energy deviation" input box, define the deviation as a % above which a meas-
uring channel should be classified as faulty.
Standard value for the max. energy deviation: 5% - 10%
Note any specifications provided by the solar module manufacturer.

Threshold

The average electric charge of all strings in Ah at which the evaluation of the "max. energy
deviation" is to start.
This will prevents status codes due to bad weather.
80
Install the Fronius Solar.access software on the PC
Administration / Create system
Systems / [Name of the system] / Settings / String Control
(1)
(1) Selecting the number (address) of
the Fronius String Control 250/30
(2) DCD DF to be set
(2)

Strings per measuring channel

(3) Limit values:
- max. energy deviation in %
- threshold value in Ah per string
(3)