Table of Contents
Advertisement
Quick Links
®
A.J. Antunes & Co.
Antunes
VCT Family
Scan with mobile device or enter URL
for product and service information.
http://tiny.cc/ajaVCT
Vertical Contact Toaster
Model VCTM-2
Owner's Manual
Manufacturing Numbers:
9210912
CAUTION: Read all instructions before using the unit.
Original Instructions
P/N 1011376 Rev. D 11/20
This manual is for the exclusive use of licensees and employees of
www.antunes.com
McDonald's Systems, Inc..
McDonald's
© McDonald's Corporation All Rights Reserved
Advertisement
Table of Contents
Related Manuals for Antunes VCT Series
Summary of Contents for Antunes VCT Series
- Page 1 ® A.J. Antunes & Co. Antunes VCT Family Scan with mobile device or enter URL for product and service information. http://tiny.cc/ajaVCT Vertical Contact Toaster Model VCTM-2 Owner’s Manual Manufacturing Numbers: 9210912 CAUTION: Read all instructions before using the unit. Original Instructions P/N 1011376 Rev.
-
Page 2: Table Of Contents
If any parts are missing or damaged, ies, butcheries, etc., But not for continuous Service/Technical Assistance problems with the installation or operation mass production of food. of this product contact Antunes Customer In Case of Damage Service immediately at +1-877-392-7856 Equipment Information to Save (toll free). -
Page 3: Safety Information Page
Inc. (BOCA) and the Food Service performed by qualified personnel Sanitation Manual of the Food y Do not block or cover any ONLY. Contact Antunes Technical and Drug Administration (FDA). openings on the equipment. Service for adjustment or repair. y Install and locate the equipment... -
Page 4: Specifications
Specifications Dimensions Electrical Ratings Model & Volts Watts Hertz Mfg. No. VCTM-2 9210912 208-230 3100 14.9/13.4 50/60 Canada Electrical Cord & Configurations Model & Description Configuration Mfg. No. VCTM-2 NEMA 6-20P, 20 9210912 Amp., 250 VAC., Canada Right Angle Model & Width Depth Height Mfg. -
Page 5: Installation
Connect the unit to the NOTE: Missing or damaged parts? Hang the back of the Bun Chute on proper power supply. Refer Contact Antunes Customer the rear Conveyor Cover hinge. When to the specification plate Service at +1-877-392-7856 (toll properly installed, the Bun Chute supports will be flush against the front for proper voltage. - Page 6 Installation Butter Feeder Wheel Bun Chute Assembly Release Sheet connected over the rear Conveyor Cover Hinge Platen Rear Cleated Belt Wrap Front Cleated Belt Wrap Rear Conveyor Cover Assembly Front Conveyor Cover Assembly Chute Figure 2. Components P/N 1011376 Rev. D 11/20 ®...
-
Page 7: Operation
Operation Set the Bun Thickness Adjustment Controls (Figure 3). Butter Wheel and Pan NOTE: The McDonald’s “Gold Standard” for toasting is the deciding factor on the finished product, not the Bun Thickness setting. NOTE: The default Bun Thickness settings are 2 for Crown Front and 2 for Heel Rear, but settings are adjustable from 1-6. -
Page 8: Hi-Limit Reset Button
4. Press the Menu button to move to the continuous resetting, contact SPEd (Speed setting). Edit as needed. Antunes Technical Service. Power Line Voltage Press the Menu button to move to the * The first circles shown in these values Unit setting. -
Page 9: Maintenance
Maintenance Close the Conveyor Covers. Reinstall the Release Sheet, Bun Daily Cleaning Chute, and Bun Feeder and return the toaster to operation. WARNING Turn the power off, unplug the power cord, and allow the unit to cool to room temperature before performing any service or maintenance. -
Page 10: Checking The Conveyor Belt Chains
Replacing Conveyor Belt Chains Checking the Conveyor Belt Chains Turn the power off, unplug the power cord, and allow the unit to cool before Measuring Conveyor Belt Chains proceeding. Turn the unit off, unplug the power Remove the Bun Chute and set the cord, and allow the unit to cool. -
Page 11: Fault Codes
Reset Hi Limit, turn unit off and back on again. If error persists, con- tact Antunes Technical Service for assistance 877-392-7854. Cannot measure power line voltage Failed on-board transformer Turn unit off and back on again. If error persists, contact Antunes used for power control (T1). Technical Service for assistance 877-392-7854. -
Page 12: Troubleshooting
Circuit breakers turned off or tripped. Damaged Reset circuit breakers. If they trip again, check the power electrical outlet, plug, or cord. Power switch dam- cord,plug, and outlet for damage. Contact Antunes Technical Ser- No Control Display aged vice for assistance 877-392-7854. -
Page 13: Replacement Parts
Parts list (see Exploded diagrams below) 0507559 Chain Tensioner Bracket Note 0507560 Motor Mounting Bracket Use only genuine Antunes replacement parts in this unit. Spring, Compression 0600143 Use of parts other than those supplied by the manufacturer Setting will void the warranty. - Page 14 Replacement Parts Continued Item Item Part # Description QTY. Part # Description QTY. End Housing Cover 306P105* Screw, Mach. #6-32 X 1/2” 0013313 Assembly 308P102* Washer, Int. Tooth #8 Nut, Hex Keps #06-32 308P115* Screw, Mach. #8-32 X 3/8” 306P130* Steel;...
- Page 15 Exploded Diagram 1 131 68 P/N 1011376 Rev. D 11/20 ®...
-
Page 16: Exploded Views
Exploded View 2 P/N 1011376 Rev. D 11/20 ®... - Page 17 Exploded View 3 P/N 1011376 Rev. D 11/20 ®...
- Page 18 Exploded View 4 P/N 1011376 Rev. D 11/20 ®...
-
Page 19: Wiring Diagram
101.6 Wiring Diagram www.ajantunes.com FOR INFORMATION CALL 1-800-253-2991 WIRING DIAGRAM # WHT # BLK WIRE LEGEND # GRN/YEL 208/240V 12 GA XLPE 50/60HZ 14 GA TEF 3000W MAX # 18 GA PVC # BLK 20 GA XLPE MAIN ∆ 22 GA TFE SSR1 1900W 22 GA XLPE... -
Page 20: Limited Warranty
Travel Time & Mileage in excess of 2 hours (100 miles/160 km) round trip from the nearest authorized service agency. Antunes reserves the right to make changes in design or add any improvements on any product. The right is always reserved to modify equipment because of factors beyond our control and government regulations.
Need help?
Do you have a question about the VCT Series and is the answer not in the manual?
Questions and answers