Page 1
® A.J. Antunes & Co. Antunes VCT Family Scan with mobile device or enter URL for product and service information. http://tiny.cc/ajaVCT Vertical Contact Toaster Model VCTM-2 Owner’s Manual Manufacturing Numbers: 9210909 CAUTION: Read all instructions before using the unit. Original Instructions P/N 1011371 Rev.
If any parts are missing or damaged, ies, butcheries, etc., But not for continuous Service/Technical Assistance problems with the installation or operation mass production of food. of this product contact Antunes Customer In Case of Damage Service immediately at +1-877-392-7856 Equipment Information to Save (toll free).
Inc. (BOCA) and the Food Service performed by qualified personnel Sanitation Manual of the Food y Do not block or cover any ONLY. Contact Antunes Technical and Drug Administration (FDA). openings on the equipment. Service for adjustment or repair. y Install and locate the equipment...
Bun Chute NOTE: Missing or damaged parts? Platen (Figure 2). Verify that supports will be flush against the front Contact Antunes Customer it is properly in place before of the unit (Figure 1). Service at +1-877-392-7856 (toll proceeding.
Page 6
Installation Bun Feeder Butter Wheel Bun Chute Assembly Release Sheet connected over the rear Conveyor Cover Hinge Platen Rear Cleated Belt Wrap Front Cleated Belt Wrap Rear Conveyor Cover Assembly Front Conveyor Cover Assembly Chute Figure 2. Components P/N 1011371 Rev. E 10/20 ®...
Operation Set the Bun Thickness Adjustment Controls (Figure 3). Butter Wheel and Pan NOTE: The McDonald’s “Gold Standard” for toasting is the deciding factor on the finished product, not the Bun Thickness setting. NOTE: The default Bun Thickness settings are 2 for Crown Front and 2 for Heel Rear, but settings are adjustable from 1-6.
4. Press the Menu button to move to the continuous resetting, contact SPEd (Speed setting). Edit as needed. Antunes Technical Service. Power Line Voltage Press the Menu button to move to the * The first circles shown in these values Unit setting.
Maintenance Close the Conveyor Covers. Reinstall the Release Sheet, Bun Daily Cleaning Chute, and Bun Feeder and return the toaster to operation. WARNING Turn the power off, unplug the power cord, and allow the unit to cool to room temperature before performing any service or maintenance.
Replacing Conveyor Belt Chains Checking the Conveyor Belt Chains Turn the power off, unplug the power cord, and allow the unit to cool before Measuring Conveyor Belt Chains proceeding. Turn the unit off, unplug the power Remove the Bun Chute and set the cord, and allow the unit to cool.
Reset Hi Limit, turn unit off and back on again. If error persists, contact Antunes Technical Service for assistance 877-392-7854. Cannot measure power line voltage Failed on-board transformer Turn unit off and back on again. If error persists, contact Antunes used for power control (T1). Technical Service for assistance 877-392-7854.
Internal temperature of control compartment ex- proper spacing. Clean cooling fan if needed, if not rotting, contact Toaster displays ERR 10 ceeded 160° F. Antunes Technical Service. Check if cooling fan is functioning. If not, replace fan. P/N 1011371 Rev. E 10/20 ®...
Parts list (see Exploded diagrams below) 0507560 Motor Mounting Bracket Note 0600143 Spring, Compression Setting Use only genuine Antunes replacement parts in this unit. 0800455 Rod, Knob (Heel) Use of parts other than those supplied by the manufacturer 0800457 Rod, Knob (Crown) will void the warranty.
Page 14
Replacement Parts Continued Item Item Part # Description QTY. Part # Description QTY. 4010221 Cap-Mp, Motor Run 306P102* Washer, Int. Tooth #6 4010245 Switch, Rocker 306P105* Screw, Mach. #6-32 X 1/2” 4030352 Thermostat, Hi-Limit 700°F 308P102* Washer, Int. Tooth #8 4030455 Aux Heater, 200Vac, 550W 308P115*...
Page 15
Exploded Diagram 1 Used on Mfg. No. 9210911 ONLY Used on Mfg. No. 9210910 ONLY 131 68 Used on Mfg. No. 9210911 ONLY P/N 1011371 Rev. E 10/20 ®...
101.6 Wiring Diagram www.ajantunes.com FOR INFORMATION CALL 1-800-253-2991 WIRING DIAGRAM # WHT # BLK WIRE LEGEND # GRN/YEL 208/240V 12 GA XLPE 50/60HZ 14 GA TEF 3000W MAX # 18 GA PVC # BLK 20 GA XLPE MAIN ∆ 22 GA TFE SSR1 1900W 22 GA XLPE...
Travel Time & Mileage in excess of 2 hours (100 miles/160 km) round trip from the nearest authorized service agency. Antunes reserves the right to make changes in design or add any improvements on any product. The right is always reserved to modify equipment because of factors beyond our control and government regulations.
Need help?
Do you have a question about the VCT Series and is the answer not in the manual?
Questions and answers