Hard Disk Initialization (Formatting) - Kyocera FS-7000 Instruction Manual

Hard Disk Initialization (Formatting)

After installing the hard disk in the printer, the disk must to be initialized (format-
ted) before used. Initialization is performed from the printer's control panel
following the installation. The initialization procedure is described in the follow-
ing.
1. After confirming that the HD-2 hard disk is installed in the printer, turn
on the printer.
2. The printer's ATTENTION indicator flashes for a while, and the message
display indicates Format error HARD DISK. This is the state when
the printer is turned on the first time after the hard disk has been installed.
Note Even while Format error HARD DISK is displayed, the printer
can be used for normal printing without using the hard disk.
3. Press the printer's MODE key in this state, and use the + or – key to
display HARD DISK >.
4.
When the
5. When the ENTER key is pressed, ? is displayed. Press the ENTER key
once more to have the printer initialize (format) the hard disk.
6.
When initialization is completed, the printer's message display changes to
indicate Ready. This completes initialization of the hard disk, which is
now ready for use.
Caution when Turning the Power OFF
To protect the hard disk, always make sure that the printer's message display
indicates Ready before the printer is turned off.
key is pressed, >Format is displayed.
9