Kyocera FS-7000 Instruction Manual page 19

Printing Accumulated VMB Data with a Password
This function prints VMB data protected by a password which has accumulated in
a virtual output tray.
1. Display HARD DISK > and press the
data Tray. The VMB tray number will appear in the location marked
by #'s below, while the VMB tray name will appear in the location
marked by %'s.
>Print VMB data
Tray###:%%%%%%%
2. Pressing the ENTER key will cause a ? to flash.
>Print VMB data
Tray###?%%%%%%%
3. Each time the + or – keys are pressed, the VMB data display will change.
Press the CANCEL key if you want to halt printing. The ? display will
disappear.
4. If a password is set for the VMB data you want to print, the message
display will change to >User ID? 00001 and the printer will standby
to accept a password. The cursor will blink in the one's place of the
displayed number. Enter the correct password. Use the
change places and the + or – keys to change the displayed number.
Passwords from 00001 to 65535 can be entered.
5. Press the ENTER key once the correct password is entered.
Processing will be displayed and the data will be printed. If the
password was incorrect, an error message will be displayed (see page 22).
Pressing the CONTINUE key will return the printer to Ready status.
Note that the password entered here is reset (returns to 00001) when this mode is
exited.
key to display >Print VMB
and keys to
19