Kyocera FS-7000 Instruction Manual page 14

3. When the ENTER key is pressed, the message display indication changes
to Processing. Following this, the indication changes to Waiting.
Processing
To stop data writing, press the CANCEL key.
4.
In this state, the computer sends data to the printer.
Example: To send the file named TEST.TXT to the printer (DOS mode).
While the printer is receiving the data, the message display indication
changes to Processing. When data reception is completed, the
indication changes to Waiting.
5. After confirming that the message display indication has changed to
Waiting, press the FORM FEED key.
The printer automatically prints out the information of the data that has just been
written to the hard disk (see example below).
This enables you to check the name of the data (partition) and whether the data has
been written correctly.
Data type: Indicates the type of data (only 2 supported)
Partition name: Name of written partition (data)
Write data length: Written partition data amount (unit = byte)
Following printing, the message display indication returns to Ready.
14
COPY TEST.TXT PRN
Waiting