Introduction; Names Of Parts - Kyocera FS-7000 Instruction Manual

Introduction

The HD-2 is an optional hard disk for use with the Kyocera Page Printer FS-6700/
FS-7000/FS-7000+.
The hard disk is a precision instrument. To ensure correct use, please read this
manual thoroughly so that you understand the correct installation and operation
methods.
Packing List
HD-2
Instruction manual (this booklet)
Note
To enable the use of the HD-2 hard disk, the minimum printer
memory requirement is 8 MB. However, we strongly recommend at
least 12 MB of memory when using this hard disk. Consult an
authorized Kyocera dealer or Service Center for details on the
expansion memory chip.

Names of Parts

Before installing the hard disk, please study the following part names. These names
are used in describing procedures for installing and using the hard disk.
Access lamp
After installation in the
printer, the lamp lights while
the hard disk is accessed.
1
1
Hard disk cover
Do not apply force.
Connector
Connects to the
connector inside
the printer.
Hard disk unit
(HD-2)
7