Installing The Hard Disk In The Printer - Kyocera FS-7000 Instruction Manual

Installing the Hard Disk in the Printer

The HD-2 hard disk is installed in the location marked OPT2 on the rear panel.
CAUTION
1.
Detach the cover over the slot (OPT2) for optional devices as shown in
the illustration.
FS-6700
2.
Remove the HD-2 from the package and insert it with care by sliding it
along the rails inside the slot in the printer as shown in the illustration.
3.
After proper insertion, clamp the HD-2 using the two screws removed in
step 1 above. This completes installation of the hard disk.
FS-6700
8
Before installing (or removing) the HD-2 hard disk, be sure to
turn off the printer's power and disconnect the power cord
plug from the AC outlet.
It is possible to move an HD-2 hard disk that has been
installed in one printer to another printer if the printers are
the same model. However, if the HD-2 is moved to a different
model printer, data accumulated on the HD-2 will be lost.
Note that in this case, the HD-2 can still be used if it is
formatted, but the accumulated data is lost.
Cover of the slot (OPT2) for optional devices
Screws
Rail
Rail
FS-7000/FS-7000+
FS-7000/FS-7000+