Outputting To A Vmb - Kyocera FS-7000 Instruction Manual

Outputting to a VMB

When sending data to a virtual output tray set within the HD-2, make this setting
from the printer driver. With this setting, data can be sent by specifying the desired
virtual output tray number. It is also possible to assign a name to a virtual output
tray and send data by specifying that name. (For details on this setting, please refer
to the help documentation for the printer driver.)
When data is sent by specifying a virtual output tray, printing to paper is not
performed at the time data is sent. Sent data accumulates in the virtual output trays
of the HD-2. For details on printing accumulated data, please see the next item.
Printing Accumulated VMB Data
This function prints VMB data accumulated in a virtual output tray.
1. Display HARD DISK > on the printer's MODE SELECT menu and
press the
number will appear in the location marked by #'s below, while the VMB
tray name will appear in the location marked by %'s.
>Print VMB data
Tray###:%%%%%%%
2. Pressing the ENTER key will cause a ? to flash.
>Print VMB data
Tray###?%%%%%%%
3. Each time the + or – keys are pressed, the VMB data display will change.
Press the CANCEL key if you want to halt printing. The ? display will
disappear.
4. Display the VMB data you want to print. Pressing the ENTER key will
cause Processing to be displayed and the data will be printed.
18
key to display >Print VMB data Tray. The VMB tray