Error Messages - Kyocera FS-7000 Instruction Manual

Error Messages

If any of the following error messages concerning the hard disk is shown on the
printer's message display, please check and take remedial action as indicated in the
following table. If the trouble cannot be eliminated by taking the prescribed
actions, please contact your dealer for advice.
Error Message
Format error
HARD DISK
HARD DISK error 01
Press CONTINUE
HARD DISK error 02
Press CONTINUE
HARD DISK error 03
Press CONTINUE
HARD DISK error 04
Press CONTINUE
HARD DISK error 05
Press CONTINUE
HARD DISK error 06
Press CONTINUE
HARD DISK error 10
Press CONTINUE
HARD DISK error 20
Press CONTINUE
HARD DISK error 85
Press CONTINUE
HARD DISK error 86
Press CONTINUE
HARD DISK error 88
Press CONTINUE
HARD DISK error 89
Press CONTINUE
HARD DISK error 97
Press CONTINUE
22
Initialization (formatting) of the hard disk is required.
Initialize the hard disk.
(Refer to page 9.)
Hard disk format error.
If this error recurs even if the power has been turned off and
then on, reformat the hard disk.
The disk system is not installed. Recheck the requirements
for using the system and the devices.
Cannot write in the hard disk system because write
protection is enabled.
Disable write protection.
There is no available hard disk space.
Delete unnecessary files, etc., in order to free up space.
The specified file does not exist in the hard disk.
There is no memory available to the hard disk system.
Increase the available memory.
Formatting is not possible because host data is being
spooled on the hard disk.
Wait until the hard disk is ready, and then format.
The hard disk was installed in the incorrect slot. Reinstall
the hard disk in a different slot.
VMB: Alias error
(The alias setting was lost, or the virtual bin corresponding
to the alias does not exist.)
Set the alias again.
VMB: Password error
(There is no password specified, the password is incorrect, or
the password setting is lost.) Confirm the correct password.
VMB: An unreadable job or page was found while output-
ting the jobs in a virtual bin. (The job is damaged.)
VMB: A virtual bin that was specified for output does not
contain any jobs, or the virtual bin is not being used.
Confirm the bin.
MPS: The number of nonvolatile jobs reached the limit
value, and no more can be saved. Either delete some
unnecessary jobs, etc., or increase the limit.
Remedy