Chapter 3 Power Supply; Board Power Connection - Renesas PiggyBack 144QFP User Manual

Chapter 3 Power supply

3.1
R20UT3282ED0101 Rev. 1.1
2015-06-10

Board power connection

For operation of the device, a supply voltage must be connected to the board.
There are several possibilities to power the device.
Within this document the following voltages are considered as 'typical'
connections:
Voltage1 = 3.3V
Voltage2 = 1.25V
Direct voltage supply
Two different voltages can be supplied to the board.
The following connectors are available to supply those voltages directly:

Three 4mm 'banana-type' connectors:
- Two red connectors for voltages Voltage1 (CN13) and Voltage2 (CN14).
- A black connector for ground (GND) connection (CN12).
Note: The three connectors are supplied with the board but not assembled.
For details about voltage distribution, refer to Chapter 3.2 'Voltage distribution'.
Supply by E1 emulator
The E1 emulator that is used for debug purposes and flash programming can
also supply a single operating voltage ('Dbg_Voltage'). This voltage is connected
to Voltage1.
See the documentation of the E1 and Chapter 5 'Debug and Programming
interface' for details.
Supply by MainBoard
In case the PiggyBack board is mounted on a MainBoard, the voltage Voltage1 is
supplied by the on-board regulator of the MainBoard.
CAUTION: Do not supply Voltage1 directly to the PiggyBack board in case it is
mounted on the MainBoard.
For each of the voltages, Voltage1 and Voltage2 a green LED is available to
signal that the related voltage is available on the PiggyBack board. The
corresponding LEDs are placed directly beneath the connectors of the related
voltage.
6