Section 3.06: Drain Waste Tank Mode - Advantage Engineering TRANS PRO X Series Operation Manual

IV. Operating Procedures
3.06 DRAIN WASTE TANK – OPERATING PRODECURE
(Used ATF is transferred from the internal waste tank of TRANS PRO through the drain
adapter to external waste ATF reservoir with this mode)
Power up. Connect power cord to 12.0 VDC battery. REFER TO BATTERY VOLTAGE CHART
ON PAGE 14. Connect the positive lead of the equipment to the positive lead of the battery
first. Connect the negative lead of the equipment to vehicle ground as far away from the bat-
tery as the leads will allow to prevent sparking and igniting of battery gases. Note: The
REVERSED POLARITY LED will light if connected improperly.
The TRANS PRO will self test. The buzzer will sound, all LEDs and display segments will light
briefly, and software version will be displayed.
The SELECT key and DIPSTICK ONLY, MANUAL/TOP-OFF, DRAIN WASTE TANK, AND TOTAL
COUNT LEDs will light and flash (additional COOLER LINE LED visible on TRANS PRO+
model).
Depress the SELECT key until the LED for the proper function is lit. (Note: The lit LED will
move from option to option i.e. MANUAL/TOP-OFF, DRAIN WASTE TANK, and TOTAL COUNT,
etc. each time it is depressed). When the LED for the DRAIN WASTE TANK mode is lit and
flashing, pause for one second.
Attach drain adapter to red hose and place into external waste ATF reservoir.
The ENTER key LED will then light and flash. Depress ENTER to confirm.
Display will register used ATF being discharged.
The buzzer will sound and the FINISH and ENTER LEDs will flash when the drain cycle is com-
pleted. Depress ENTER key. Depress ENTER again.
The TRANS PRO will display "SR FIN," "Service Finished." when the waste tank is completely
drained.
22
Advantage Engineering® TRANS PRO X-Series™
Manual Printed in the U.S.A. for AEC GROUP INC.
Operations Manual