Table of Contents
Advertisement
Advantage Engineering® TRANS PRO X-Series™
3.02
OVERVIEW OF TRANS PRO X-SERIES AUTOMATIC
TRANSMISION FLUID EXCHANGING SERVICE MODES
The TRANS PRO can perform an ATF exchange, drain the transmission pan, and/or top off
ATF levels in vehicles that have a dipstick. A fluid exchange service is possible in the cooler
line mode (TRANS PRO+ feature). The mode selected when performing an ATF exchange
may determine the comprehensiveness of the service.
Dipstick Only – no adapters to the cooler lines are used
Dipstick adapter is inserted into transmission's dipstick tube
(used ATF and new ATF are transferred through the transmission's dipstick to the trans-
mission system with this mode)
Step 1: Technician selects the quantity of ATF to be used for the service (default is 12
quarts). Minimum is 6 quarts, maximum is 32 quarts.
Step 2: With engine off, TRANS PRO extracts used ATF from the transmission
pan through the transmission's dipstick tube.
Step 3: With engine off, TRANS PRO pumps back the same volume of new
ATF to the transmission's pan through the transmission dipstick tube.
Step 4: The engine is started, circulating new ATF through the transmission fluid circuits;
returning old system fluid to the transmission pan.
Step 5: TRANS PRO extracts one (1) quart of now diluted ATF, and returns one (1)
quart of new ATF through the dipstick to the transmission pan. This step is repeated
until the ATF volume selected for the service is reached.
Cooler Only (Trans Pro+ feature) – adapters to the cooler lines are used
(used ATF and new ATF are transferred through the transmission's cooler line with this
mode)
Step 1: Technician locates cooler line, points of connection, and adapters for this mode.
Adapters are connected with the engine off.
Step 2: Technician selects the quantity of ATF to be used for the service (default is 12
quarts). Minimum is 6 quarts, maximum is 32 quarts.
Step 3: After the Trans Pro+ is activated and the engine is started, the Trans Pro+ X-series
senses pressure from transmission and allows transfer of 1 quart used ATF through
cooler line. Trans Pro+ X-series returns 1 quart new ATF through cooler line. This
to/from continues until the ATF volume selected for the service has been transferred.
M
/T
O
ANUAL
OP
FF
(used ATF and new ATF are transferred through the transmission's dipstick to the trans-
mission system with this mode)
This mode is used commonly used when the transmission pan needs to be removed (to
change gaskets or replace filter). It is also used to top off the ATF fluid level when necessary.
Operations Manual
Manual Printed in the U.S.A. for AEC GROUP INC.
IV. Operating Procedures
15
Advertisement
Table of Contents
