Advantage Engineering TRANS PRO X Series Operation Manual page 22

Advantage Engineering® TRANS PRO X-Series™ IV. Operating Procedures
Pause after the correct volume is selected. The ENTER key LED will light and flash.
Depress ENTER to start the transfer of fluid.
When the TO TRANS or FROM TRANS function is finished, the CHECK TRANS LEVEL LED
will light. Check the ATF level with dipstick. If further adjustment is desired, repeat the above
sequence. When satisfied with fluid level, depress SELECT to illuminate FINISH LED. Depress
ENTER to confirm completion of desired mode. Display will indicate SR FIN.
If the DRAIN PAN is selected, follow the procedure below.
Depress ENTER to start the service. TRANS PRO purges internal fluid lines and then
extracts used ATF from the transmission pan until empty.
When the DRN PAN service is complete, the CHECK TRANS LEVEL LED will light. TO
TRANS, FROM TRANS, FINISH, and FINISH LEDs will light. The display will also flash DRN
PAN. Complete the transmission pan service (i.e. filter change/gasket change).
When the transmission pan service is complete (i.e. filter change/gasket change), depress
SELECT, toggling between the flashing selections until the TO TRANS LED is lit. Pause for
one second. Depress ENTER to confirm. The volume of fluid extracted from the DRN PAN
service is shown on the right display. Depress the ADD (ARROW UP) key to enter the volume
of new ATF to be added. Depress ENTER. TRANS PRO will transfer selected volume of new
ATF to transmission pan.
The procedures, TO TRANS and FROM TRANS can be repeated. Note the fluid level after
each procedure. When the fluid level is satisfactory confirm by selecting FINISH. Pause for
a second. The ENTER LED will flash. Depress the ENTER key. Depress ENTER again.
The TRANS PRO will display SR FIN "Service Finished."
Operations Manual 21
Manual Printed in the U.S.A. for AEC GROUP INC.