Setting The Scsi Id - Minolta Dimage Scan Multi Hardware Manual

Konica minolta dimage scan multi: hardware guide
Hide thumbs Also See for Dimage Scan Multi:
Table of Contents

Advertisement

The Dimâge Scan Multi's SCSI ID is factory preset to 5. If 5 is not being used by another operating SCSI device in the
SCSI chain, it is not necessary to change the SCSI ID.
A SCSI ID is a unique address you assign to each SCSI device connected to your computer. The SCSI ID range of
your computer is from 0 to 7, however some IDs are already occupied by your computer.
IBM PC/AT:
Macintosh:
TO CHANGE THE SCSI ID:
1. Turn off the computer and all connected SCSI devices.
2. Determine which SCSI IDs are not being used.
3. Change the SCSI ID using the upper or lower SCSI buttons.

SETTING THE SCSI ID

Occupied SCSI ID
7 (SCSI host adapter)
0 (internal hard drive)*
3 (internal CD-ROM drive)**
7 (system)
* IDE Macintosh systems do not use SCSI ID 0 for the hard drive.
** Macintosh systems with a dual bus have SCSI ID 3 available on the external bus.
TURN OFF THE COMPUTER AND ALL THE SCSI DEVICES
BEFORE CHANGING SCSI IDS, CONNECTING SCSI
CABLES, OR DISCONNECTING SCSI CABLES.
Press the upper button to select a smaller SCSI number.
The current SCSI ID number.
Press the lower button to select a higher SCSI number.
8

Advertisement

Table of Contents
loading

Table of Contents