Setting The Scsi Id - Minolta DIMAGE SCAN SPEED Manual

SETTING THE SCSI ID

A SCSI ID is a unique address you assign to each SCSI device connected to your computer.
The SCSI ID range of your computer is from 0 to 7, however some ID's are already occupied.
* IDE Macintosh systems do not use SCSI ID 0 for the hard drive.
** SCSI ID 3 is available on the external bus on Macintosh systems with a dual bus.
Setting the SCSI ID
1. Turn off the computer and all connected SCSI
devices.
2. Determine which SCSI IDs are not being used.
3. Using a pointed object, set the switches to an
unused SCSI ID.
• The Dimâge Scan Speed's SCSI ID is factory preset to 5. If 5 is not
occupied, there is no need to change the SCSI ID.
• Two operating SCSI devices in the same SCSI chain cannot share a
SCSI ID.
SCSI ID Dip Switch Settings
8
Turn off the computer and all the devices in the SCSI chain
before changing SCSI IDs, connecting, or disconnecting SCSI
cables. Hardware damage may occur if this precaution is not
followed.
IBM PC/AT 7 - SCSI host adapter
0 - internal hard drive*
Macintosh 3 - internal CD ROM drive**
7 - operating system
Occupied SCSI ID