Installing The Software; Windows 95/Windows Nt - Minolta Dimage Scan Multi Hardware Manual

WINDOWS 95/WINDOWS NT

• These installation instruction assume drive D is the CD-ROM drive.
1. Turn on the Dimâge Scan Multi, then turn on your PC.
2. Start Windows 95 or Windows NT.
3. This step varies with your specific operating software...
Windows 95
• The New Hardware Found dialog box will appear.
3. Click on Cancel.
• This dialog box may appear several times. Repeat
step 3 until the dialog box no longer appears.
Windows NT
3. Select START – SETTINGS – CONTROL PANEL, then double-click on the SCSI Adapters
icon. Confirm that Minolta #2883 appears as a connected device for your SCSI board.
• If Minolta #2883 does not appear, turn the system off and check all the connections. Repeat the procedure.
4. Insert the Dimâge Scan Multi CD-ROM into the CD-ROM drive.
5 From the START button, select RUN...
• The Run dialog box will appear.

INSTALLING THE SOFTWARE

Windows 95 Release 2 (OSR2)
• The appearance and/or wording of some dialog
boxes may vary.
• The following dialog box will appear.
3a. Click on Next.
• A similar dialog box will appear.
3b. Click on Finish.
• This dialog box may appear several times. Repeat
step 3 until the dialog box no longer appears.
36