Konica Minolta Magicolor 2300W User Manual page 92

Symptom
Printing
takes too
much time.
Blank pages
come out
during a print
job.
Not all pages
print.
84
Cause
The printer is set to a
slow printing mode
(for example, thick
stock or
transparency).
The printer is set to
power saving mode.
The job is very
complex.
One or more of the
toner cartridges are
defective or empty.
The wrong media is
being used.
The printer has the
wrong kind of cable,
or the printer is not
configured for the
correct cable and
port.
The Cancel key was
pressed.
The media tray is
empty.
A document is printed
with an overlay file
which has been
created by a
non-magicolor2300W
driver.
Solution
It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
It takes time for printing to start in
power saving mode. If you do not want
to use this mode, disable it (Status
Display's Print/Maintenance... menu).
Wait. No action needed.
Check the toner cartridges. The image
does not print if the cartridges are
empty.
Check that the media type set in the
driver matches the media loaded in the
printer.
Check your cable.
Make sure no one pressed the Cancel
key while your job was printing.
Check that the media trays are loaded
with media, in place, and secure.
Print the overlay file using a magicolor
2300W printer driver.
Solving Other Problems