Lan1/2 (Ethernet Ports); Unit Identifi Er Switch/Uid Led Indicators - Supero SUPERSERVER 6017R-M7UF Manual

LAN1/2 (Ethernet Ports)

Two gigabit Ethernet ports (LAN1 and
LAN2) are located on the I/O back-
plane. These ports accept RJ45 type
cables. The X9DRL-7F also includes
a dedicated IPMI LAN port above the
rear USB ports to provide KVM sup-
port for IPMI 2.0.
Unit Identifi er Switch/UID LED
Indicators
A Unit Identifier button (JUIDB), a
backplane LED indicator and a front
panel UID header are provided on the
serverboard. The UID button is located
next to the VGA port on the backplane.
The rear UID LED indicator (LED1) is
located next to the UID button. The
front panel UID LED header is located
at pins 7/8 of JF1. Connect a cable to
pin 8 on JF1 for the front panel UID
LED connection. When you press the
UID button, both the rear UID LED
and the front panel UID LED will turn
on. Press the UID button again to turn
off both LEDs. These UID indicators
provide easy identifi cation of a system
that may be in need of service.
Note: UID can also be triggered via
IPMI on the serverboard. For more
information on IPMI, please refer to
the IPMI User's Guide posted on our
website: http://www.supermicro.com.
Chapter 5: Advanced Serverboard Setup
LAN Port
Pin Defi nitions
Pin# Defi nition Pin#
1 P2V5SB 10
2 TD0+ 11
3 TD0- 12
4 TD1+ 13
5 TD1- 14
6 TD2+ 15
7 TD2- 16
8 TD3+ 17
9 TD3- 18
UID Button
Pin# Defi nition
1 Ground
2 Ground
3 Ground
4 Button In
UID LED
Status
Color/State OS
Blue: On Windows OS
Blue: Linux OS
Blinking
5-19
Defi nition
SGND
Act LED
P3V3SB
Link 100 LED
(Yellow, +3V3SB)
Link 1000 LED
(Yellow, +3V3SB)
Ground
Ground
Ground
Ground
Status
Unit Identifi ed
Unit Identifi ed