Table of Contents
Advertisement
SUPERSERVER 6017R-M7UF/6017R-M7RF User's Manual
SGPIO Headers
Four SGPIO (Serial General Purpose
Input/Output) headers are included on
the serverboard. These headers are
used to communicate with the System
Monitoring chip on the backplane and
provide a serial interface to the SAS/
SATA ports. T-SGPIO 1/2 supports the
I-SATA ports while 6-SGPIO 0/1 sup-
ports the SAS ports. See the table on
the right for pin defi nitions.
DOM Power Connector
A power connector for SATA DOM
(Disk On Module) devices is located at
JSD1. Connect an appropriate cable
here to provide power support for your
Serial Link DOM devices.
TPM/Port 80 Header
A Trusted Platform Module/Port 80
header is located at JTPM1 to provide
TPM support and Port 80 connection.
Use this header to enhance system
performance and data security. See
the table on the right for pin defi nitions.
Overheat LED/Fan Fail
The JOH1 header is used to connect
an LED indicator to provide warnings
of chassis overheating and fan failure.
This LED will blink when a fan failure
occurs. Refer to the tables on right for
pin defi nitions.
SGPIO Headers Pin Defi nitions
Pin#
Defi nition
1
NC
3
Ground
5
Load
7
Clock
Note: NC indicates no connection.
DOM PWR
Pin Defi nitions
Pin#
Defi nition
1
+5V
2
Ground
3
Ground
TPM/Port 80 Header
Pin Defi nitions
Pin #
Defi nition
1
LCLK
3
LFRAME#
5
LRESET#
7
LAD 3
9
+3.3V
11
LAD0
13
SMB_CLK4
15
+3V_DUAL
17
GND
19
LPCPD#
Overheat LED
Pin Defi nitions
Pin#
Defi nition
1
5vDC
2
OH Active
OH/Fan Fail LED
Status
State
Solid
Blinking
5-18
Pin
Defi nition
2
NC
4
Data
6
Ground
8
NC
Pin #
Defi nition
2
GND
4
<(KEY)>
6
+5V (X)
8
LAD 2
10
LAD1
12
GND
14
SMB_DAT4
16
SERIRQ
18
CLKRUN# (X)
20
LDRQ# (X)
Message
Overheat
Fan Fail
Advertisement
Table of Contents
