Table of Contents
Advertisement
6-5
Power Supply
6017R-M7UF
The SuperServer 6017R-M7UF has a single 400 watt power supply. This power
supply has the capability of operating with an input voltage of 100-240V. A second
identical power suppy (PWS-406P-1R) may be installed for redundancy or a BBP
(Battery Backup Power Supply, PWS-206B-1R) can be installed to provide backup
power.
Power Supply Failure
If the power supply unit fails, the system will shut down and you will need to replace
the power supply unit. Replacement units can be ordered directly from Supermicro
(see contact infomation in Chapter 1).
Replacing the Power Supply
1. First depress the main power button on the front of the chassis then unplug
the AC power cord from the power supply unit.
2. Push the release tab on the power supply to the side to unlock it, then pull
the power supply straight out of the chassis.
3. Replace the failed unit with another unit with another of the same part number
(the exact same power supply).
4. Carefully insert the new unit into position in the chassis and push it in until
fully seated.
5. Reconnect the AC power cord to the new power supply.
6. Finish by depressing the power button on the control panel to reboot the
system.
Chapter 6: Advanced Chassis Setup
6-7
Advertisement
Table of Contents
