安装远程接口控制器（有线 - Wine Guardian D200 Installation, Operation And Maintenance Manual

系统温度诊断
安装远程接口控制器（有线）
图 1
图 2
图 3
图 4
图 5
46
警报
1. Disconnect the communication cable from the side of
the Wine Guardian unit and the remote interface controller. (Fig. 1)
1. 从酒卫装置和远程接口控制器一侧
断开通信电缆。（图 1）
a. Route the communication cable within the wall
and/or ceiling structure of the wine cellar to the desired controller
mounting location.
a. 在墙内
和/或酒窖的吊顶结构上计划安装控制器的位置布设通信电缆。
b. Plan on mounting the remote interface controller on a solid
surface away from doors, corners, air outlets, drafts or heat
generating equipment. Do not mount the remote interface
controller directly on an outside wall, a wall adjacent to a boiler
room, or other hot area. Use a piece of foam insulation behind
the sensor to insulate it from a hot or cold surface. The
recommended height is four to five feet above the finished floor.
请计划将远程接口控制器安装在远离门、角落、出风口、通风或
b.
发热设备的固体表面上。请勿将远程接口控制器直接安装在外墙、邻
近锅炉房的墙壁或其他高温区域内。请在传感器后面使用一块泡沫绝
缘材料将其与热表面或冷表面隔离。建议高度为竣工地面以上 4 至 5
英尺。
2. Remove the back plate of the controller (Fig. 2) by removing two (2) screws
that hold it in place on the remote interface. Place the back plate against the
wall and mark the location of the two mounting points (Fig. 3). Also mark the
location of the penetration for the communication cable as this area will
require sufficient clearance for the cable to exit the wall and attach to the back
of the controller.
2. 卸下将控制器背板固定在远程接口上的两（2）个螺钉，从而卸下控制器背板
（图 2）。将背板靠墙放置，并标记两个安装点的位置（图 3）。同时标记通信
电缆的穿透位置（因为该区域需要足够的间隙以使电缆隔开墙壁并附着到控制
器的背面）。
3. Drill two one-eighth inch holes and insert anchors at the marked locations.
Anchors may not be required if securing to a wall stud or racking system.
Insert the screws into the holes and test fit the backing plate to ensure it
mounts easily onto the two screws and slides down onto the slotted opening
freely (Fig. 4).
3. 在标记位置钻两个八分之一英寸的孔并插入锚。如果是固定在墙柱或支架系
统上，可能不需要锚。将螺钉插入孔中，并测试安装背板，以确保其可以很容
易安装到两个螺钉上，并可顺利滑入开槽开口（图 4）。
无法使用
高温、低温。
高湿度、低湿度。
高压故障。
冷凝、除霜、通信错误