Table of Contents
Advertisement
with a set of default values. Press F7 to install the setup utility with
a set of high-performance values.
Standard CMOS Setup Page
Use this page to set basic information such as the date and time,
the IDE devices, and the diskette drives. If you press the F3 key,
the system will automatically detect and configure the hard disks
on the IDE channels.
Date & Time
Use these items to install your system with the
correct date and time
Pri Master
Use these items to configure devices on the
Pri Slave
primary and secondary IDE channels. To
configure a hard disk drive, choose Auto. If the
Sec Master
Auto setting fails to find a hard disk drive, set it to
Sec Slave
User, and then fill in the hard disk characteristics
(Size, Cyls, etc.) manually. If you have a CD-
ROM drive, select the setting CDROM. If you
have an ATAPI device with removable media
(e.g. a ZIP drive or an LS-120) select ARMD.
Floppy Drive A
Use these items to set the size and capacity of
the floppy diskette drive(s) installed in the
Floppy Drive B
system.
Hardware Monitor Page
29
Advertisement
Table of Contents
