Installing A Socket-370 Processor - PCchips M748LMRT Manual

4. Locate the cooling fan power supply FAN1. Connect the cable
from the processor cartridge cooling fan to FAN1.
5. Locate the jumper JP7. Use this jumper to select if you have
installed a Slot-1 processor or a Socket-370 processor. The
jumper settings are illustrated below.
1
Selects a Socket-370
processor
6. On this mainboard, you can configure the processor by
entering the correct settings in the BIOS setup utility.

Installing a Socket-370 Processor

The Celeron processor installs into the ZIF (Zero Insertion Force)
Socket-370 on the mainboard.
1. Locate the Socket-370, FAN1, and JP7. Pull the locking lever
out from the socket and swing it to the upright position.
JP7
2. On the Celeron processor, identify the pin-1 corner by noting
that it has a slight bevel.
3. On the Socket-370, identify the pin-1 corner. The pin-1 corner
is on the same side as the locking lever, closest to the top of
the lever when it is in the locked position.
Install the Processor
JP7
1
Selects a Slot-1
processor
FAN1
Socket-370
Pin-1 Corner
11