Settings Of The 4 Dip Switches (Can Function - Red); Installation - r.LiNK CI-RL4-MIB Manual

1.5. Settings of the 4 Dip switches (CAN functions – red)
All 4 dip-switches of the video interface have no function for normal
use and have to be set to OFF (except Porsche vehicles with PCM 4.0).
Dip position down is ON and position up is OFF.
Vehicle/Navigation
All vehicles
Porsche with PCM 4.0
For Porsche vehicles with PCM 4.0: If the Can communication does not work with the upper
shown dip positions, other dip combinations can also be tried out.
After each Dip-switch-change a power-reset of the Can-box has to be performed!

2. Installation

To install the interface, first switch off the ignition and disconnect the vehicle's battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
If the necessary stabilized power supply for the interface is not taken directly from the
battery, the chosen connection has to be checked for being constantly stabile.
The interface needs a permanent 12V source!
Version 16.03.2022
Dip 1 Dip 2
OFF OFF
OFF
HW:CAM(V100)/(V33)
Dip 3 Dip 4
OFF OFF
ON OFF Off
CI-RL4-MIB