IBM BladeCenter QS20 Problem Determination And Service Manual page 69

Figure 12. Mounting point and position description
10. Optional: repeat the above steps for the second InfiniBand option.
11. Prepare the new front bezel by attaching the control panel and serial cable
connectors onto the blade's board.
12. Partially insert the side fins of the bezel into the metal guides while ensuring
that the top of the bezel rests on the foam gasket on the InfiniBand card as
shown in Figure 13 on page 52.
Note: Make sure the serial cable, routed along the inside and across the
bottom of the bezel, is housed underneath the blade's board
13. After you have checked the routing, fully latch the bezel to the blade.
Chapter 5. Installing and removing replaceable units
51