NTI UNIMUX Series Installation And Operation Manual page 10

NTI UNIMUX 4K 18GBPS HDMI USB KVM SWITCH
Notes：
[*1]: "++" means press 2 times in quick succession,
For example: [Scroll] ++ [Scroll] + [1] means press Scroll key twice in quick succession, then press the number "1" again
The detection timeout between each hotkey code is 2 seconds, so if the Scroll key is pressed once, and then pressed again
after 2 seconds, the hotkey combination will be invalid.
[*2]: "n" can be numbers 1/2/3,
For example: "Scroll ++ Scroll + S + 1 + 2 + 0" means to press the "Scroll" key twice in quick succession, then press the letter "S"
and release it, press the number "1" key and release it, then press the number "2" key and release it, and lastly press the number
"0" key and release it. The result will be to set the polling time interval to 120 seconds.
[*3]: "CTRL" and "SHIFT" keys can be used regardless of whether they are left or right.
[*4]: The hotkey [Ctrl + Shift + 1] means pressing and holding the "Ctrl" key, then pressing and holding the "Shift" key, and then
pressing the number "1" key and releasing all keys.
NOTE: Only one of the four hotkey switch modes can be used at a time.
For example; When you use the "Scroll" mode to switch, the other three modes will not work. If you want to switch to other hotkey
modes, please operate according to the above tables.
Auto Polling
When Auto Polling is turned ON, the UNIMUX will automatically switch from one port to the next port for the length of time polling
has been configured for. The UNIMUX will switch from port 1, to port 2, to port 3, to port 4 and back to port 1.
Auto Detect
When Auto-Detect is turned ON, the switch will automatically detect the connection of the connected computer's USB interface (at
USB ports 1-x) and perform intelligent switching.

If it detects that a new computer's USB interface is connected, it will automatically switch to the newly connected
computer;

If the USB interface is disconnected, it will automatically switch to the next connected computer.

If it is detected that the USB interface of the non-enabled computer is disconnected, the connections will not be switched.

If you turn ON the Auto-Detect function and then also turn ON the Auto Polling function, the UNIMUX will automatically
skip the USB port that does not have a computer connected.
Mouse Buttons
If your mouse has three buttons, it can be used to change ports on the UNIMUX.
Pressing the center button and left or right button will cause the UNIMUX to switch
to the previous or next port (respectively).
7