Bornack ONE FLEX User Manual page 12

SPECIAL INFORMATION ABOUT
HORIZONTAL USE
The tape energy absorber with a lanyard
ONE FLEX and ONE FLEX have also been
tested successfully according to
CNB/P/11.074 for horizontal use and a
resulting simulated fall over the edge.
A burr-free steel rod with an edge radius
r = 0.5 mm was used. Based on this test,
ONE FLEX and ONE FLEX are suitable for
use on similar edges, for instance on
rolled steel profiles or parapet panels.
Regardless of this test, if the device is
used horizontally or at an incline where
there is a risk of falling over an edge, the
following information and additional
instructions in this User Manual also
need to be taken into account.
ONE FLEX IN USE
CAUTION:
Also check the following in the risk
assessment:
• Is the radius of the fall edge greater
than 0.5 mm?
• Is the edge burr-free?
If this is not the case, precautions should
be taken:
• Use a retention system to rule out a
fall.
• Attach a suitable edge protection.
• Contact the manufacturer.
12 | 13