Maintenance; System Maintenance Procedures; Adding A Rectifier Module To An Existing Spec. No. 588705000, 588705400, Or 588705500 Module Mounting; Assembly - Vertiv NetSure 7100 Series User Manual

4 Maintenance

4.1 System Maintenance Procedures

It is recommended to perform the maintenance procedures listed in Table 4.1 every 6-months to ensure continual system operation.
Table 4.1 Maintenance Procedures to be Performed at 6-Month Intervals
PROCEDURE
Check ventilation openings for obstructions such as dust, papers,
manuals, etc.
Inspect and tighten all installer's connections.
4.2 Adding a Rectifier Module to an Existing Spec. No. 588705000,
588705400, or 588705500 Module Mounting Assembly
To increase system current capacity, a rectifier module can easily be added to an existing Spec. No. 588705000, 588705400, or
588705500 module mounting assembly that contains an empty rectifier module mounting position.
It is recommended that the current limit point be checked whenever a rectifier module is added to or removed from a 588705000,
588705400, or 588705500 module mounting assembly in the power system. Refer to "Checking the Controller's Current Limit Point
after Adding or Removing a Rectifier Module or Converter Module" on page 44.
The rectifier module being added is assigned by the controller the lowest available identification number. If desired, you can change
the identification number. Refer to the NCU Instructions (UM1M830BNA) for a procedure.
•
For rectifier module installation instructions in a 588705000 and 588705500 shelf, refer to Rectifier Instructions
(UM1R483500e).
•
For rectifier module installation instructions in a 588705400 shelf, refer to Rectifier Instructions (UM1R483500e3).
Vertiv™ NetSure™ 7100 Series -48 VDC Power System User Manual
REFERENCED IN
IM582127000, "Making Electrical Connections" section.
--
15