Table of Contents
Advertisement
6
Chapter 6: Setup Page
Navigating the Setup Page
To navigate to the Setup Page follow the steps below:
1. From the Home Page, press and hold both the Up or Down keys
appear in the red display and
released where
opEr
additional 3 seconds.
2. Press the Up or Down key
3. Press the Advance Key to enter the menu of choice.
4. If a sub-menu exists (more than one instance), press the Up or Down key
press the Advance Key to enter.
5. Press the Up or Down key
6. Press the Reset Key to move backwards through the levels: parameter to sub-menu, sub-menu to
menu, menu to Home Page.
7. Press and hold the Reset Key for two seconds to return to the Home Page.
On the following pages, top level menus are identified with a yellow background color.
Note:
Some of these menus and parameters may not appear, depending on the controller's options. See
model number information in the Appendix for more information. If there is only one instance of a
menu, no sub-menus will appear.
Note:
Some of the listed parameters may not be visible. Parameter visibility is dependent upon controller
part number.
Ai
Analog Input Menu
sEt
1
Analog Input (1 to 2)
Ai
Sensor Type
sEn
TC Linearization
Lin
RTD Leads
rt. L
Units
Unit
Scale Low
s. L o
Scale High
s. h i
Range Low
r. L o
Range High
r. h i
* These parameters/prompts are available with firmware revisions 11.0 and
above.
Wa t low P M LE GAC Y ™ L imi t Co ntro ll er
will appear in the green display. If the up and down arrow keys are
SEt
appears in the green display, simply press and hold those same keys for an
to view available menus.
to move through available menu prompts.
Process Error Enable
P. E E
Process Error Low Value
P. E L
Thermistor Curve
t. C
Resistance Range
r. r
Filter
fiL
Input
Error Latching
i. E r
Display Precision
dEC
Calibration Offset *
i. C a
Analog Input
ain
Input Error
i. E r
gLbL
sEt
gLbL
C_f
aC. L f
C. L Ed
2onE
d. p rs
d. t i
Usr. s
Usr. r
Value *
*
49
•
•
for six seconds.
Ai
to select and then
Global Menu
Global
Display Units
AC Line Frequency
Communications LED Action
Zone
Display Pairs
Display Time
Save Settings As
Restore Settings From
C hapter 6 Setup Page
will
Advertisement
Table of Contents
