Chapter 6: Setup Page - Watlow ez-zone pm User Manual

6

Chapter 6: Setup Page

Navigating the Setup Page
To navigate to the Setup Page follow the steps below:
1. From the Home Page, press and hold both the Up ¿ and Down ¯ keys for six seconds.
will appear in the upper display and
arrow keys are released where
an additional 3 seconds.
Note: (for firmware release 13 and below)
If keys are released when
and repeat until
2. Press the Up ¿ or Down ¯ key to view available menus.
3. Press the Advance Key
4. If a submenu exists (more than one instance), press the Up ¿ or Down ¯ key to select and
then press the Advance Key
5. Press the Up ¿ or Down ¯ key to move through available menu prompts.
6. Press the Infinity Key ˆ to move backwards through the levels: parameter to submenu, sub-
menu to menu, menu to Home Page.
7. Press and hold the Infinity Key ˆ for two seconds to return to the Home Page.
On the following pages, top level menus are identified with a yellow background color.
Note:
Some of these menus and parameters may not appear, depending on the controller's op-
tions. See model number information in the Appendix for more information. If there is
only one instance of a menu, no submenus will appear.
Note:
Some of the listed parameters may not be visible. Parameter visibility is dependent upon
controller part number.
Ai
sEt
Analog Input Menu
Sensor Type
sEn
TC Linearization
Lin
RTD Leads
rtL
Units
Unit
Scale Low
s. L o
Scale High
s. h i
Range Low
r. L o
Range High
r. h i
Process Error En-
P. E E
able
** These parameters/prompts are available with firmware revisions 11 .0 and above .
Watl o w EZ-ZO N E ® P M P ID Co n t r o l le r
SEt
opEr
is displayed, press the Infinity Key
opEr
is displayed.
SEt
to enter the menu of choice.
‰
to enter.
‰
P. E L
t. C
r. r
fiL
i. E r
dEC
i. C a
ain
i. E r
will appear in the lower display. If the up and down
is displayed, simply press and hold those same keys for
Process Error Low
Value
Thermistor Curve
Resistance Range
Filter
Input Error Latch-
ing
Display Precision
Calibration Offset *
Analog Input Value *
Input Error *
6 0
• •
or reset key to exit
ˆ
Lnr
sEt Linearization Menu
Function
fn
Source Function A
sfn. a
Source Instance A
Si. a
Source Zone A
sz. a
Units
Unit
Input Point 1
ip. 1
Output Point 1
op. 1
Input Point 2
ip. 2
Output Point 2
op. 2
Input Point 3
ip. 3
Chapter 6 Setup Pa ge
Ai