Table of Contents
Advertisement
5
Chapter 5: Operations
PM Operation Page Parameters
To navigate to the Operations Page, follow the steps below:
1. From the Home Page, press both the Up and Down keys
the red display and
2. Press the Up or Down key
3. Press the Advance Key to enter the menu of choice.
4. If a sub-menu exists (more than one instance), press the Up or Down key
press the Advance Key to enter.
5. Press the Up or Down key
6. Press the Reset Key to move backwards through the levels: parameter to sub-menu, sub-menu to
menu, menu to Home Page.
7. Press and hold the Reset Key for two seconds to return to the Home Page.
On the following pages, top level menus are identified with a yellow background color.
Note:
Some of these menus and parameters may not appear, depending on the controller's options. See
model number information in the Appendix for more information. If there is only one instance of a
menu, no sub-menus will appear.
Note:
Some of the listed parameters may not be visible. Parameter visibility is dependent upon controller
part number.
Ai
Analog Input Menu
opEr
1
Analog Input (1 to 2)
Ai
Analog Input Value
Ain
Input Error
i. E r
Calibration Offset
i. C A
dio
Digital Input/Output Menu
opEr
1
Digital Input/Output (5 to 6)
dio
Output State
do. S
Input State
di. S
Event Status
Ei. s
Wa t low P M LE GAC Y ™ L imi t Co ntro ll er
will appear in the green display.
oPEr
to view available menus.
to move through available menu prompts.
for three seconds.
LiЛЏ
Limit Menu
opEr
1
Limit
LiЛЏ
Low Limit Set Point
LL. S
High Limit Set Point
Lh. S
Clear Limit
LCr
Limit Status
L. S t
aLЛЏ
Alarm Menu
opEr
1
Alarm (1 to 4)
aLЛЏ
Low Set Point
A. L o
High Set Point
a. h i
Clear Alarm
a. C Lr
Silence Alarm
a. S ir
Alarm State
a. s t
43
•
•
will appear in
Ai
to select and then
C hapter 5 Op erati ons Page
Advertisement
Table of Contents
