Acyclic Data - Siemens Sitrans Probe LU Instruction Manual

Oxley Creek WWTP Water Reclamation
(Probe LU Manual) Vendor Manual
LCD
display

Acyclic Data

SITRANS Probe LU supports up to four simultaneous connections by a Class 2 Master
(C2 connection). It supports one connection by a Class 1 Master (C1 connection). A list of
all acyclic data, including address (slot and index), format, range of values, start value,
and attributes, can be found at
page 61.
Page 32 SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL
Cause/symptom (cont' d )
Factory calibration for the
device has been lost.
Factory calibration for the
device has been lost.
Unable to start microwave
module.
Microwave module hard-
ware defect: Unable to col-
lect profile.
Microwave module hard-
ware failure: unable to cal-
culate distance
measurement.
Transducer temperature
sensor failure.
Transducer temperature
too high.
Transducer temperature
too low.
Factory calibration for the
transducer temperature
sensor has been lost.
Appendix G: Asynchronous Communications Data Map
Corrective Action (cont'd)
Repair required: contact your
local Siemens representative.
Repair required: contact your
local Siemens representative.
Repair required: contact your
local Siemens representative.
Repair required: contact your
local Siemens representative.
Repair required: contact your
local Siemens representative.
Reset power. If fault persists,
contact your local Siemens rep-
resentative: repair required.:.
Relocate device and/or lower
process temperature enough to
cool device. Inspect for heat-
related damage and contact
your local Siemens representa-
tive if repair is required.
Relocate device and/or raise
process temperature enough to
warm device. Inspect for dam-
age and contact your local Sie-
mens representative if repair is
required.
Repair required: contact your
local Siemens representative.
Doc Id: VM11
Active Date: 15/12/2006
Byte Bit
2
3
4
5
4
6
7
0
5
1
2
on
7ML19985JB02