Siemens Sitrans Probe LU Instruction Manual page 87

Oxley Creek WWTP Water Reclamation
(Probe LU Manual) Vendor Manual
2.4.3. Low Calibration Pt. (default 6 m)
Distance from Sensor Reference Point to Low Calibration Point (corresponding to
Low Level Point). Unit is defined in Sensor units (open the menu
2.4.4. High Calibration Pt. (default 0)
Distance from Sensor Reference Point to HIgh Calibration Point (corresponding to
High Level Point). Unit is defined in Sensor units (open the menu
2.4.5. Unit (Level): default %
Selected engineering units for Level (PV).
•
•
Hand
programmer
values
2.4.6. Low Level Point (default 0)
The level when the material is at Low Calibration Point. The unit is defined in Level
units (open the menu
to see an illustration.)
7ML19985JB02
, then click on
1. Open the menu
for Wet or Dry calibration.
2. Enter the values for Low Calibration Point, Low Calibration Level,
High Calibration Point, High Level Point, then click on
, then click on
1. Open the menu
for Wet or Dry calibration.
2. Enter the values for Low Calibration Point, Low Calibration Level,
High Calibration Point, High Level Point, then click on
Referenced from Low Level Point (plus level offset, if any)
Can be any linear measurement (commonly selected units shown below)
1. Open the menu
for Wet or Dry calibration.
2. Enter the values for Low Calibration Point, Low Calibration Level,
High Calibration Point, High Level Point, then click on
SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL
, to see an illustration.)
, to see an illustration.)
mm
ft
in
%
, then click on
Doc Id: VM11
Active Date: 15/12/2006
, and click on the button
.
, and click on the button
.
, and click on the button
.
Page 81
,