Parameter Adjustment - Quick Setup; Parameter Adjustment - Extended Adjustment - Siemens SITRANS LG260 Operating Instructions Manual

Switch-on phase
Measured value indica-
tion
Quick setup
PBD-51041059
After switching on, the SITRANS LG260 carries out a short self-test
where the device software is checked.
The output signal transmits a fault signal during the switch-on phase.
The following information is displayed on the display and adjustment
module during the startup procedure:
•
Instrument type
•
Device name
•
Software version (SW-Ver)
•
Hardware version (HW-Ver)
With the [->] key you can move between three different indication
modes.
In the first view, the selected measured value is displayed in large
digits.
In the second view, the selected measured value and a correspond-
ing bar graph presentation are displayed.
In the third view, the selected measured value as well as a second
selectable value, e.g. the temperature, are displayed.
6.4

Parameter adjustment - Quick setup

To quickly and easily adapt the sensor to the application, select
the menu item "Quick setup" in the start graphic on the display and
adjustment module.
The following steps for the quick setup can be reached also in the
"Extended adjustment".
•
Instrument address
•
Measurement loop name
•
Medium type (optional)
•
Application
•
Max. adjustment
•
Min. adjustment
•
False signal suppression
You can find the description of the individual menu items in the follow-
ing chapter "Parameter adjustment - Extended adjustment".
6.5

Parameter adjustment - Extended adjustment

For technically demanding measuring points, you can carry out
extended settings in "Extended adjustment".
SITRANS LG260 - Operating Instructions
25