Table of Contents
Advertisement
5.2.2
Plug assignments (RJ45)
The data transfer of the RoughCam IPM2036 uses a 100 Mbit/s Ethernet connection
(100BASE-TX). If the cable termination uses a plug, the latter should be plugged into the
RJ45 PoE slot of the network device (PSE). Prior to connecting it to the camera, the net-
work device (PSE) can already be supplied with power, hence there is no „power ON"
priority which has to be observed.
Attention!
Use appropriate RJ45 plugs! Check the cable shielding, cross-section
and the outside diameter!
Attention!
It is imperative to ensure a correct routing of the individual wires ac-
cording to the EIA/TIA-568B"
Attention!
Finally, check your network installation with a Class-D Link Test.
Detailed instructions on how to connect a RJ45 plug are available in our video tutorial:
"SAMCON 03 Mounting and installing the RJ45 jack to SAMCON cables"
https://go.samcon.eu/v03
Figure 5-8 Plug assignment, RJ45
Doc.-ID: 220815-PT10BA-ES-RoughCam IPM2036_en_rev.00.docx, Page 19 of 28
Advertisement
Table of Contents
