Table of Contents
Advertisement
In order to avoid consequential
damage, do not continue working
with the machine if a rake (1) or one
of its tines (2) is broken. Always
replace a damaged rake – see
chapter on "Maintenance".
SP 81
Assembling the Machine
2
A
2
3
Mounting the Carrying Ring
:
Mount the carrying ring (1) about
1 cm (distance A) in front of the
control handle (2) as follows.
:
Position the open carrying ring (1)
on the drive shaft with its tapped
hole on the left (user side).
:
Squeeze the ends of the carrying
ring together and insert the M6x14
screw (3).
:
Line up the carrying ring.
Tighten down the screw firmly.
1
1
Mounting the Gearhead
:
Place the power tool on the ground
so that it rests on the machine
support.
:
Loosen the clamp screws (1) on the
gearhead – do not remove them.
:
Apply a mark (with pencil or crayon)
at distance A (40 mm) from the end
of the drive tube.
:
Remove the protective cap from the
end of the drive tube.
English
1
1
13
Advertisement
Table of Contents
