Table of Contents
Advertisement
English
Symbol on slide control
h (7) – stop symbol and arrow – to stop
the engine, push the slide control in the
direction of the arrow on the stop symbol
(h) to STOP-O.
Starting
:
Hold down the trigger interlock and
pull the throttle trigger.
:
Keep both levers in that position.
:
Move the slide control to START
position and hold it there.
:
Now release the throttle trigger,
slide control and trigger interlock in
that order. This is the
starting-throttle position.
18
8
9
:
Set the choke lever (8):
For cold start to g
For warm start to e
(also use this setting if the engine
has been running but is still cold)
:
Press the fuel pump bulb (9) at least
five times – even if the bulb is filled
with fuel.
8
:
Place the unit on the ground: It must
rest securely on the engine support.
Rest the gearhead on a raised
support (high mound) or the fork of
a branch. Check that the rakes are
not touching the ground or any other
obstacles.
:
Make sure you have a firm footing.
:
Press the unit firmly against the
ground with your left hand. Your
thumb should be under the fan
housing.
:
Pull the starter grip slowly with your
right hand until you feel it engage –
and then give it a brisk strong pull.
Do not pull out starter rope to full
length – it might break.
:
Do not let the starter grip snap back
– guide it slowly into the housing so
that the starter rope can rewind
properly.
:
Continue cranking.
SP 81
Advertisement
Table of Contents
