Table of Contents
Advertisement
English
Maintenance
5
6
4
Removing and Installing
the Rakes
Removing
:
Use a suitable tool to remove the
chain connector as follows:
Pry off the spring clip (1), remove
the tie strap (2) and pull out the
chain connector (3).
:
Loosen the locknuts (4), unscrew
them from the pivot pin (5) and take
off the washers (6).
:
Pull out the pivot pin (5).
:
Remove the rake.
28
:
Clean the chain connectors and the
forkhead.
3
:
Check the condition of the O-rings
and replace them if there are any
4
signs of damage.
6
:
Squeeze the tube of STIHL SP
bearing grease to obtain a short
length of grease.
:
Coat each pin with bearing grease.
Installing
:
Assemble and install in the reverse
sequence.
Checking Rake Clearance
:
Close the rakes and set them to
their closest point – the forkhead
should be at the bottom of its stroke.
:
Grip the gullets of the inner tines
and gently squeeze the rakes
together.
:
Measure the distance (a) between
the tips of the tines – do not bend
the tines in this process.
SP 81
Advertisement
Table of Contents
