Table of Contents
Advertisement
:
Place the clamp (7) in the loop
handle (3) and position them both
against the drive tube (8).
:
Fit the clamp (9) and place the
barrier bar (6) on the handle,
making sure it is positioned as
shown.
:
Line up the holes.
:
Insert the screws (10) in the holes
and screw them into the barrier bar
as far as stop.
:
Go to "Adjusting the handle".
SP 81
Mounting loop handle without
barrier bar
:
Place the clamp (7) in the loop
handle (3) and position them both
against the drive tube (8).
:
Fit the clamp (9) and line up the
holes.
:
Fit the washers (11) on the screws
(10) and insert the screws in the
holes. Screw them into the square
nuts (5) as far as stop.
:
Go to "Adjusting the handle".
Adjusting the handle
:
Line up the handle and adjust it to
the most favorable position for the
user and application.
Distance A must not be more than
55 cm. About 35 cm is
recommended.
:
Tighten down the screws on handle
firmly.
Removing the handle
It is advisable to remove the loop
handle to use the basic power tool
for its original purpose.
:
Remove the loop handle and keep
all the parts in a safe place for future
use.
English
11
Advertisement
Table of Contents
