Storing The Machine; Replacing The Nylon Line - Stihl FSB-KM Instruction Manual

Storing the Machine

For periods of about 3 months or longer:
: Remove, clean and inspect the
cutting attachment.
: If the CombiTool is stored
separately, fit the protective cap on
the drive tube to avoid dirt getting
into the coupling.
: Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
FSB-KM

Replacing the Nylon Line

STIHL AutoCut 11-2
Always inspect the mowing head for
wear before replacing the nylon line.
If there are signs of serious wear,
replace the parts concerned or
install a new mowing head.
Preparations
: Switch off the engine.
: Lay the brushcutter on its back with
the mowing head facing up.
1
2
Removing Remaining Nylon Line
: Open the mowing head – hold it
steady with one hand and unscrew
the cap (1) counterclockwise.
: Disengage the spool (2), take it out
of the mowing head and remove the
remaining nylon line.
Winding Line Onto Spool
A prewound spool – see 'Special
Accessories' – may be installed
instead of fitting individual lines.
English
17