Table of Contents
Advertisement
How to use
NOTE:
- Calido is factory set to start at a moisture level of 88%.
The moisture level starting point can be adjusted between 40-88%
using nine levels.
- Moisture level is indicated by three LEDs, each LED indicates where the third level
(3, 6 and 9th level, each step change sensitivity by 6%)
- When the set humidity level is reached Calido works in forced extraction mode. When
the humidity later falls below the set level, the unit will continue at forced for 20
minutes to stabilize the moisture level.
Then returns to its normal Calido heat exchange operation.
(Please carefully consider the humidity level when changing it from 88%. During summer, when the relative
humidity can be high, it may be necessary to adjust the starting point to a higher level to prevent Calido from
being forced into exhaust air mode only.)
Speed control
- Main unit
Push
Low
- Remote Control (optional on request)
Select, Low Mid High
Humidity control
- Main unit
Push
to change the moisture sensitivity
(9 steps, 40-88%)
Settings
8
to change the flow into
20, 40 or 60m³/h
Mid
High
Advertisement
Table of Contents
