Miele H 7890 BP Operating And Installation Instructions page 59

 Immerse the end of the water intake
pipe in the container with tap water.
 Confirm with OK.
The intake process will begin.
The amount of water actually drawn up
into the oven may be less than the
amount specified as required, leaving a
small amount in the container.
The intake process can be interrupted
and restarted at any time by selecting
Stop or Start .
 Remove the water container after the
water intake process and close the
door.
The sound of the pump running can be
heard again briefly. Residual water in
the water intake pipe is being drawn
into the oven.
The oven heating and cooling fan will
switch on. The required and the actual
temperature will appear.
You will see the temperature rising in
the display. A buzzer will sound when
the selected temperature is reached for
the first time.
If you have selected
can check the time before steam is
released by selecting
Injecting bursts of steam

Danger of injury caused by
steam.
Steam can cause severe scalding.
In addition, steam condensing on the
control panel will cause the sensor
controls and the touch display to
react more slowly.
Do not open the door during a burst
of steam.
Automatic
The steam is released automatically
after the heating-up phase.
The water will evaporate in the oven
compartment and
appear in the display.
After the burst of steam,
will disappear.
 Continue cooking until the end of the
programme.
Moisture Plus
With Timer , you
 Info .
will
Burst of steam
Burst of steam
59