Introduction; Your Safety; Notes For Your Safety - Schwank novoSchwank D 20S U Technical Manual

novoSchwank shape U

1 Introduction

Thank you for choosing a Schwank radiant tube for
your heating-system.
Your novoSchwank is a modern radiant tube for an
economic and comfortable heating in large rooms
and industrial buildings.
Structure and operation of the heater are
according to the requirements of the existing
standards.
Please read this manual carefully before using the
heater. Pay attention to notes and warnings. The
manufacturer will not be held responsible for
damages resulting from installation errors or failure
to comply with the manufacturer's instructions.
Please pay attention to the warnings in chapter 2

"Your Safety".

The radiant tube novoSchwank must be exclusively
used for the purpose it was intended. Any other
use is to be considered improper and therefore
dangerous. Its observance is imperative for the
proper operation of our devices, and is thus the
condition for our warranty.
2 Your Safety
You will find the following symbols in this manual:
Danger!
Note that you and others can be hurt.
Attention!
Note that the appliance can be
damaged.
Danger!
Note that electrical shocks can be very
dangerous. Pay attention while working
on the electrical equipment.

Advice!
You find additional instructions about the
application/handling of the heater.
4

Notes for your safety

This appliance is designed according to the
requirements of the existing standards.
Nevertheless it is possible that dangers for you and
others result from the installation and/or operating
errors.
To avoid this, please read and follow the
instructions carefully.
General Notes
Only use the radiant tube if it is in a technically
faultless condition.
This manual is an integral and essential part of the
product and must be given to the user. Keep the
manual near the heater.
Any person pursuing any of the following tasks must
read this manual:
 operating
 assembling
 installation
 commissioning
 maintenance / trouble shooting
You need an explicit permission from the
manufacturer for any kind of changes and
reconstruction.
Use original spare parts only.
Safety for the electrical equipment
Danger of electrical shocks!
Electrical shocks can be very dangerous!
The electrical installation must be carried out by a
qualified service engineer following the existing
national and international standards.
Check the electrical equipment regularly.
Defect wires etc. must be replaced immediately.
The appliance must be cut off from the power
supply while working with the electrical equipment.
Make sure that nobody can connect the
appliance to the power supply while you are
installing or maintaining the kit.
After-sales Service
For all installation operations, start-up, gas
changes, etc. always consult a qualified service
engineer.
In case of doubt, contact SCHWANK GmbH,
phone + 49 [0] 221 / 7176 0.