Introduction; Your Safety; Notes For Your Safety - Schwank infraSchwank D 15U Technical Manual

1 Introduction

Thank you for choosing a high efficiency SCHWANK
radiant tube.
Your infraSchwank D / calorSchwank D is a modern
and low-pollution tube heater for economic and
comfortable heating of industrial and commercial
buildings.
The design and operation of the heater are according
to the requirements of the existing standards.
Please read this manual carefully before using the
heater. Please follow carefully all instructions and
warnings. The manufacturer will not be held
responsible for damages resulting from installation
errors or failure to comply with the manufacturer's
instructions.
Grey marked text shows information to two-stage or
modulating operation for tube heaters
infraSchwank D / calorSchwank D
Follow carefully all warnings in chapter 2 "Your
Safety".
These tube heaters are constructed exclusively for the
application of large industrial and commercial space
heating. Any other use is not permitted and therefore
Schwank is not liable for any improper use.

2 Your Safety

You will find the following symbols in this manual:
Danger!
Note that you and others can be hurt.
Attention!
Note that the appliance can be damaged.
Danger!
Note that electrical shocks can be very
dangerous. Pay attention while working on
the electrical equipment.

Advice!
You find additional instructions about the
application/handling of the heater.
infraSchwank D / calorSchwank D - shape U

Notes for your safety

This appliance is designed according to the
requirements of the existing standards. Nevertheless
it is possible that dangers for you and others result
from the installation and/or operating errors.
To avoid this, please read and follow the instructions
carefully.
General Notes
Only use the radiant tube if it is in a technically
faultless condition.
This manual is an integral and essential part of the
product and must be given to the user. Keep the
manual near the heater.
Any person pursuing any of the following tasks must
read this manual:
 operating
 assembling
 installation
 commissioning
 maintenance / trouble shooting
You need an explicit permission from the manufacturer
for any kind of changes and reconstruction.
Use original spare parts only.
Safety for the electrical equipment
Danger of electrical shocks!
Electrical shocks can be very dangerous!
The electrical installation must be carried out by a
qualified service engineer following the existing
national and international standards.
Check the electrical equipment regularly.
Defect wires etc. must be replaced immediately.
The appliance must be cut off from the power supply
while working with the electrical equipment. Make
sure that nobody can connect the appliance to the
power supply while you are installing or maintaining
the unit.
After-sales Service
For all installation operations, start-up, gas changes,
etc. always consult a qualified service engineer.
In case of doubt, please contact:
Mr. John Balass
Devex Systems Pty Limited
5/83 Bassett St
Mona Vale NSW 2103
Tel: 02 9997 2811
Fax: 02 9997 7852
E-mail: info@devexsystems.com.au
3