Table of Contents
Advertisement
I N S T A L L A T I O N G U I D E L I N E S
HIBERNATION MODE
This mode disables motors and most electronics in order to reduce wear on the fixture's internal components.
The user has the ability the define the period of time that the fixture can remain inactive before it enters
hibernation mode. This feature can be accessed by navigating in the main menu to PERSONALITY >
STATUS SETTINGS > HIBERNATION (see the System Menu section of this manual for detailed information).
The default setting for hibernation delay time is 15 minutes, but it can be adjusted from 1 min to 99 min, or
switched off completely.
• Hibernation mode is activated when the fixture enters hibernation after the timeout expires. Default is 15
minutes.
• Hibernation mode is deactivated when DMX signal is connected.
The fixture will perform a full calibration cycle, then assume the current DMX status.
Please note that the Hibernation does not change the PT position of the fixtures. This allows the user to set
the desired position and then issue the Hibernate command.
To ensure the fixture is protected from harmful sunrays, it is recommended to set the fixture to a safe Pan
Tilt position manually prior to putting the fixture in hibernation mode.
Burn and heat damage to the fixture's interior components due to external light sources (sun or other
fixtures shining into the lens) is never covered under the manufacturer's warranty.
16
Advertisement
Table of Contents
