Table of Contents
Advertisement
S Y S T E M M E N U
EFFECT ADJUST – Calibration
ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THIS FUNCTION!
This function allows small adjustments to be made to the Pan, Tilt, and Zoom movements to
compensate for ware or in the event a sensor has been knocked slightly out of place. Because
improper use of this function can result in undesired operation this function has been password
protected. The password is 050 and must be entered each time the calibration menu function is
entered. Because calibration is an extremely delicate procedure, instructions on performing this action
are left out of this manual. For a first-time calibrator, please contact our customer support team for
step-by-step instructions.
EDIT PROGRAM – Rec. Controller
The fixture features an integrated DMX-recorder by which you can transmit the programmed scenes
from your DMX-controller to the moving head. Adjust the desired scene numbers via the encoder (from
– to). When you call up the scenes at your controller, they will automatically be transmitted to the
moving head.
EDIT PROGRAM – Record Controller – Working with Built-In Programs
A Primary unit can send up to 3 different data groups to the Secondary units, i.e. a Primary unit can
start 3 different Secondary units, which run 3 different programs. The Primary unit sends the 3 program
parts in a continuous loop.
The Secondary unit receives data from the Primary unit according to the group which the Secondary
unit was assigned to. If e.g. a Secondary unit is set to "Secondary 1" in the menu "Set to Secondary",
the Primary unit sends "Auto Program Part 1" to the Secondary unit. If set to "Secondary 2", the
Secondary unit receives "Auto Program Part 2".
23
Advertisement
Table of Contents
