Air Filter Maintenance; Separator Maintenance - Sullair TSR32 User Manual

TSR32 USER MANUAL R00
5. Install the element into the filter canister.
6. Thread the canister and element back on the
filter head.
7. Restart compressor and check for leaks.
6.6

AIR FILTER MAINTENANCE

Refer to Figure 6-2. Air filter maintenance on air filter
no. 250006-718 should be performed when the
once a year, whichever comes first. If the filter needs
to be replaced, order replacement element no.
02250135-149. Consult the following procedures to
replace the air filter element.
A F E
IR ILTER LEMENT
1. Clean exterior of air filter housing.
2. Release the three retaining clamps and
remove the end cap.
3. Remove element and clean interior of
housing using a damp cloth.
E R
LEMENT EPLACEMENT
Figure 6-2: Air Filter Assembly
1. Housing
2. Element (I)
(I) Element Replacement Kit P/N 02250135-149
Element replacement is performed by reversing the
removal instructions. Make sure that the element is
fully seated into the housing.
40
lays Air Filter Maint, or
R
EMOVAL
3. Dust Collector
4. Sealing Washer
6.7

SEPARATOR MAINTENANCE

Replace the separator elements when shown by the
year, whichever comes first. The separator elements
must be replaced. DO NOT attempt to clean and
reinstall the separator elements.
S E
EPARATOR LEMENT
Refer to Figure 6-3. The separator elements must be
changed when indicated
Use the following procedure below to change the
separator elements.
Figure 6-3: Separator Element Assembly
1. Cover
2. Element-Secondary (II)
(I) Primary Element Replacement Kit P/N -
250034-124
(II) Secondary Element Replacement Kit P/N -
250034-130
SECTION 6
R
EPLACEMENT
by the Supervisor
, whichever occurs first.
3. Element-Primary (I)
4. Receiver Tank