Control Lever Pattern Operation-Machine Equipped With Excavator Front; Backhoe Control Lever Pattern - Hitachi Zaxis 200LC Operator's Manual

Control Lever Pattern Operation—Machine
Equipped With Excavator Front
CAUTION: Never place any part of body beyond
window frame to avoid serious crushing injury
from boom. Boom could lower if the control
lever is accidentally bumped or otherwise
engaged. Immediately replace a missing or
broken window.
CAUTION: Prevent injury from unexpected
control lever function. Be aware of the control
lever pattern used on the machine before
operating.
The machine comes equipped from the factory with the
excavator control lever pattern and has the corresponding
black-on-white labels installed on the left and right control
consoles.
When changed to the backhoe control lever pattern the
corresponding black-on-yellow labels must be installed on
the left and right control consoles.
Check the pattern on the labels and then carefully operate
the machine to verify that the correct labels are installed.
NOTE: A Control Pattern Selector Kit is available through
dealer parts, that when installed, changes the
control lever pattern using a solenoid valve.
See Control Lever Pattern Conversion for instructions to
change the pattern. (See procedure in this section.)
Control levers must return to neutral when released.
Functions must stop and remain positioned. Also the
parking brake for swing and travel must engage.
Operation—Operating The Machine
2-2-14
Excavator Control Lever Pattern

Backhoe Control Lever Pattern

Boom, Arm, Bucket Movement
1—Arm Out
2—Arm In
3—Swing Left
4—Swing Right
5—Boom Down
6—Boom Up
7—Bucket Load
8—Bucket Dump
OUT1739,00001F4 –19–16JUN06–1/1
081407
PN=67