Hitachi Zaxis 200LC Operator's Manual page 197

Symptom
Starter Turns But Will Not Crank
Engine
Engine Cranks Slowly
Starter Continues To Run After
Engine Starts
Charging Indicator Light On,
Engine Running
Noisy Alternator
No Monitor Panel Indicators or
Gauges Work
Miscellaneous—Troubleshooting
Problem
Starter
Battery cables damaged or broken
internally
Battery or starter cable connections
loose or corroded
Battery discharged or will not hold a
charge
Starter
Low battery voltage
Starter
Key switch malfunction
Loose or glazed alternator belt
Excessive electrical load from added
accessories
Loose or corroded electrical
connections on battery, ground
strap, starter, or alternator
Battery voltage low
Worn drive belt
Worn pulleys
Pulley misaligned
Alternator bearing
Fuse
Continued on next page
4-3-7
Solution
Repair or replace starter.
Inspect and replace cables.
Clean and tighten connections.
Recharge or replace both batteries.
Repair or replace starter.
Recharge or replace both batteries.
Repair or replace starter.
Disconnect battery ground.
Check belt. Replace if glazed.
Remove accessories or install higher
output alternator.
Inspect, clean, or tighten electrical
connections.
Charge or replace both batteries.
Replace belt.
Replace pulleys and belt.
Adjuster alternator mount.
Loosen alternator belts. Turn pulley
by hand. If any roughness is felt,
repair alternator.
Replace fuse.
OUT1739,0000255 –19–05AUG02–2/3
081407
PN=193